AFMG Network Forum
AFMG Network Forum Index -> EASE 5 -> [Bug] Loading an .emp, does not load calculation parameters
Post new topic  Reply to topic View previous topic :: View next topic 
[Bug] Loading an .emp, does not load calculation parameters
PostPosted: Thu Nov 23, 2023 4:44 pm Reply with quote
Christian
Member
 
Joined: 21 Nov 2023
Posts: 12
Location: Faroe Islands




Description:

Loading an .emp in Eyes/room mapping module, does not load calculation parameters.


Version #: 5.58.0.1665

Steps to Reproduce:

  1. make a room mapping calculation with AURA.
  2. make a loudspeaker combination and save it.
  3. close the room mapping window.
  4. reopen the room mapping windows from the ribbon.
  5. File>Load EASE Mapping file.
  6. Mapping>AURA>Calculation


Notes:

This makes it impossible to figure out what the calculation parameters where at the time of creation.
This leads to non reproducible results when sending the project to someone else.
View user's profile Send private message Visit poster's website
PostPosted: Thu Nov 23, 2023 5:08 pm Reply with quote
Christian
Member
 
Joined: 21 Nov 2023
Posts: 12
Location: Faroe Islands




I did notice in the File Info tab when viewing a mapping I can see the parameters.

But there are also discrepancies in naming, e.g "scattering method: standard" in file, whilst in the calculation tab it's "diffuse rain" on/off(checkbox).


This does still not solve the reproduction problem when sending the project file for analysis by a third party.

Workaround is to also send the result files, but now we're talking about packing the project for sending.

If the idea is to make the .eprj file be a standalone file, it should also contain calculation parameters.


What I do in the meantime is just send the entire project folder I'm working in, using alot more bandwidth and space, including all files.
View user's profile Send private message Visit poster's website
PostPosted: Fri Nov 24, 2023 12:54 pm Reply with quote
AFMG Frank Siegmann
Member
 
Joined: 18 Jul 2005
Posts: 251




Hi Christian,

yes, the calculation parameters are shown on the Info tab.

We'll revise the displayed content for forthcomming EASE versions once more.

Because there can be specific parameters for each run, they are only stored in the mapping result files.

Thank you for your feedback.
View user's profile Send private message
AFMG Network Forum Index -> EASE 5
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT  
Page 1 of 1  

  
  
 Post new topic  Reply to topic  


Powered by phpBB © 2001-2003 phpBB Group
Theme created by Vjacheslav Trushkin
Variation by CodeWeavers and AFMG